D1 PAGELASTIC

2-component, highly elastic, cement-based slurries with plastic additives

  • concrete restoration in accordance to DIN EN 1504-3
  • up to a maximum crack width alteration of 0.2 mm
  • allows water vapour diffusion
  • hinders the penetration of CO2
  • Mix: dry (dry mortar) and fluid component (mixing liquid)
  • Colour tone: grey (ca. RAL 7032)
  • consumption (2 layers): about 2,5-2,7 kg/m²
  • minimum layer thickness (2 layers): 2 mm
  • processing time at 20°C (68 °F): about 120 min
D1

Request test certificates

If you need further test certificates, please do not hesitate to contact us.
Tel. +49 201 685040
Email: pruefzeugnisse@pagel.de

Please enter your name.
Please enter a subject.
Please enter a valid phone number.
Please enter a message.

I have read the data protection declaration and I consent to the data I have provided being electronically collected and stored. My data is used only strictly for the processing and answering of my request.

You must accept the Terms and Conditions.

properties

  • crack bridging surface protection coating for masonry, mortar and concrete surfaces in non-traffic areas
  • protects against de-icing salts in spray or splash areas
  • bridge supports and curbs
  • balconies, terraces, under-tile sealing

fields of application

  • crack bridging surface protection coating for masonry, mortar and concrete surfaces in non-traffic areas
  • protects against de-icing salts in spray or splash areas
  • bridge supports and curbs
  • balconies, terraces, under-tile sealing
  • satisfies the requirements of surface protection systems OS-D I according to ZTV-ING part 3 and OS-5b according to DAfStb directive
  • bridges surface alligator-cracks and separating crack > 0.2mm, even at -20 °C (-4 °F) temperatures
  • for waterproofing of buildings, firm, adherent, resistant to ageing, impermeable to water and bridging cracks up to an alteration of the crack width of 0.2 mm
  • allows water vapour diffusion
  • hinders the penetration of CO2 (carbonation)
  • due to its texture, it can be spread with brush or trowel or in the wet-spraying method with radial air-stream nozzles
  • for colour design can be painted over with a crack-bridging surface protection system, e.g. O2DE